Waterproof Coating for Wall, Floor and Roof

Waterproofing type can in fluid form that used by spread over by brush on the floor or on the wall that need to be coating. To coat this you can use Grantkote that contain of bitumen emulsion with high quality has been grinding. Grantkote have characteristic very smooth layer can use by brush so will not break after dried.

How to use?
Before use grantkote should be stirred and no need of heating. Clean the surface of wall or floor that need to be coated from dirty and oil. Using brush spread the grantkote solution to the surface evenly. After dried, repeat it to spread over the coating place until get the suitable thickness.

The physical data of grantkote:

• Non toxic
• Drying time: 24 hours
• Fire resistance; wet not flammable, dry will burn slowly.
• Service temperature limit: - 10 to 50 ^oC
• Specific grafity: 1.03
• Shrinkage factor; approximately 45% wet to dry
• Flexibility: flexible coating within the temperature service limit

Other kind of coated material can use membrane waterproofing, this membrane waterproofing is used to the structure with fiber reinforced polyester with bitumen coating with good quality that stabilize with polymeric resins about 30%.

How to use grantseal, clean the surface from dirt and oil. To install grantseal is starting from the low level from the slope of the roof. Every joint should be install overlap minimum for about 100 mm.